Apantac KEYPAD Manuel d'utilisateur télécharger pdf (Page 4)

P a g e | 4 Apantac Keypad Configuration 7-Aug-11

Press the Beep button again. If no beep is heard, try again with

different COM port and communication speed (9600 or 38400

bps) until the beep is heard.

Hearing the beep will confirm that the communication is

established. Pressing the Get Version button will read the Keypad

FW version, pressing the Send button will display the message

next to it on the Keypad LCD display.

If the Keypad was already preloaded with AXP commands then

pressing the Keypad buttons will display them.

It is now time to create your own configuration.

Press the properties buttons and set it according to the

screen shot:

 Line Edit Mode selected

 Baud Rate set for 38.4k

 Word Format set for 8,N,1

 No LEDs

 No Card Reader

 Other parameters let to default

 You may adjust also the Key Beep parameter.

Any time you press a Keypad key, a beep is

heard for the entered duration

 Press OK when done

Now you will assign your first AXP command to a

button. Ensure that “20 keys” is checked in the

view section.

For each button configuration to be configured:

 Press the Keypad button

 Check “Transmit this key (…)”

 Enter the AXP command using the

Macromaster232 application or the

configuration PC keypad. A Macro length

warning will pop up – Just check “Don’t

show this message again”

 Repeat for the next button

Remarks:

 AXP commands are case sensitive

 All commands must be terminated by “CR” (Press the Enter key to get it)

 When using the AXP Load command the file names must be entered with their extension (*.ptx where x is a

number or *.all). Enter the name and extension you used when you saved the preset with Director

 AXP commands make use of a “|” separator. (Vertical bar)

1 2 3 4 5

Pas de commentaire

Apantac KEYPAD Manuel d'utilisateur Page 4