Apantac KEYPAD Manuel d'utilisateur télécharger pdf

P a g e | 1 Apantac Keypad Configuration 7-Aug-11

APANTAC KEYPAD Installation and Configuration

The Apantac Tahoma Control Keypad is a 20 buttons and one line LCD Display Keypad. It can control one Tahoma

series Multiviewer via the RS 232 line. Each button can be configured for sending one or more AXP (Apantac

eXchange Protocol) commands. It comes with the configuration application CD, a 5 VDC power supply, one serial

cable for configuration via a PC and one 5 meters serial cable for connection to the multiviewer.

Keypad Connection

There are two connection modes:

The Keypad set up connection to the configuration PC for and the Operation connection to the Tahoma Multiviewer.

Tahoma Multiviewer Configuration

This consists in specifying the Serial Port protocol.

Launch Director, the Apantac Tahoma Multiviewers configuration

application, and do:

System > Control Board Settings > Ensure that “Mode 1 Software Control”

is selected and “Enable 5v” is not checked > Press OK

This will ensure that the AXP commands sent by the Apantac Keypad are

understood

The Tahoma Multiviewer Serial Port communication parameters are:

Baud rate = 38400 bps, data bits = 8, parity = none, stop bit = 1, flow control = none

Regarding the AXP commands syntax, refer to the “Apantac Software Panel Configuration” and the “Apantac

eXchange Protocol” documents. The Apantac Software Panel (ASP) uses the same AXP commands as the Keypad but

over Ethernet.

Keypad Configuration

During the configuration process, connect the Keypad to the configuration PC as per the “Keypad Configuration

Connection” drawing above and plug the Keypad power supply. You will be able to configure and test the

configuration directly from the configuration PC.

Keypad Configuration Connection

Keypad Operation Connection

1 2 3 4 5

P a g e | 1 Apantac Keypad Configuration 7-Aug-11 APANTAC KEYPAD Installation and Configuration The Apantac Tahoma Control Keypad is a 20 buttons

Page 2

P a g e | 2 Apantac Keypad Configuration 7-Aug-11 You will need first to run the supplied MiniTermProSetup_v5_41_w7x64.exe application on a PC equi

Page 3

P a g e | 3 Apantac Keypad Configuration 7-Aug-11 Once the installation procedure is completed a new icon is available in the task bar. Click it to

Page 4

P a g e | 4 Apantac Keypad Configuration 7-Aug-11 Press the Beep button again. If no beep is heard, try again with different COM port and commu

P a g e | 5 Apantac Keypad Configuration 7-Aug-11 Once all the buttons have been configured, press the “Save As” button to save your work and give

Pas de commentaire

Apantac KEYPAD Manuel d'utilisateur